| Author |
Message |
Mark
| | Posted on Tuesday, March 01, 2005 - 10:58 pm: | |
What are the part numbers / manufacturer for the bearings and center seal for the four bearing crank for the T20? |
Adrian
| | Posted on Tuesday, March 08, 2005 - 2:41 pm: | |
There aren't any simple answers to this question. You have to do a fair bit of work to convert the crank.
Most use a labyrinth seal in the centre (no friction) and then some bearings that fit the casing diameter. (6005 bearings in mine I think). However, these bearings have the wrong internal diameter for the T20 crank and you have to make up a sleeve to fit them.
I have a good friend who does the conversion if you are interested... |
Mark
| | Posted on Thursday, March 10, 2005 - 5:49 pm: | |
Sure. I would like to talk (or email) your friend who does the conversion. I also plan to have the crank balanced after this conversion. I searching for some reliability though that is a tough commodity when converting a street bike to a race bike. Best Regards. |
Spen.
| | Posted on Thursday, March 10, 2005 - 9:44 pm: | |
Mark, e-mail me at spen@t20suzuki.com and I'll sort you out. |
|
Advice, help, chat, whatever!