Author |
Message |
Mark Booth
| Posted on Saturday, April 10, 2004 - 1:52 am: | |
I am finaly sending out the engine parts to be reworked. The last problem is that I can not get the rod length from the built up crank shaft. So if there is some one who has an acuate measurement for this I would be greatful. Thanks. |
Dave E.
| Posted on Saturday, April 10, 2004 - 10:38 pm: | |
con rod length, between centres is 110mm or 4.33 inches. |
Mark Booth
| Posted on Sunday, April 11, 2004 - 5:21 am: | |
Thank you so very much. |
|